TMPS33 · 6 credits · Advanced level (A1N) · Produktutveckling, Maskinteknik
Virtual Manufacturing
Discontinued · replaced by TMPR07
91%
passed the latest ordinary exam
TEN1 · 31 Oct 2024 · 11 students
82%
passed the ordinary exams, all sittings over the last 5 years
TEN1 · 55 students
Part of 6 programmes
- Master of Science in Design and Product Development
- Master of Science in Industrial Engineering and Management - International
- Master of Science in Industrial Engineering and Management
- Master of Science in Mechanical Engineering
- Bachelor of Science in Mechanical Engineering
- Master's Programme in Mechanical Engineering
Exam
TEN1 Written examination
- 5
- 4
- 3
- U
Ordinary exams
82% passed · 55 students
- 91%11
- 91%22
- 100%8
- 50%14
Re-exams
100% passed · 6 students
- 100%6
- Pass the re-exam: 100% (6 students), compared with 82% (55 students) on the ordinary exam
- Get 4 or 5: 33% (61 students)
Show small sittings (5)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 0%1
- 100%1
- 0%1
- 100%2
- 100%1
Other modules
Partial exams, hand-ins and labs. They are not part of the figures at the top.
Hand-in or lab
LAB1 Laboratory work
- G
Main rounds
100% passed · 42 students
- 100%11
- 100%22
- 100%9
Later rounds
No sittings with at least 5 students.
Show small sittings (1)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 100%1
Hand-in or lab
UPG1 Project assignment
- G
Main rounds
100% passed · 42 students
- 100%11
- 100%22
- 100%9
Later rounds
No sittings with at least 5 students.
Show small sittings (1)
Sittings with fewer than 5 students, often credit transfers or special sittings. They are not part of any figure on this page.
- 100%1
About the course
Aim
After completing the course, the student should be able to:
- practically use geometry-oriented simulation for the engineering of production systems and the production aspects in product design.
- describe and discuss modeling and simulation as a tool for engineering and its potential and limitations.
- describe and discuss the aspects of industrial robots which are connected to engineering of production systems with the use of modeling and simulation, for example offline programming.
- describe and discuss virtual manufacturing as part of and its support for the development process for products and production systems, for example PLM, Virtual Commissioning.
Content
Modeling and Simulation is the base of modern engineering. Various kinds of models and simulation tools are used in every engineering effort today. Naturally this applies also to the engineering of production systems and the production aspects in product design, which is the content of this course. Geometry-oriented simulation is in focus.
Virtual manufacturing, the simulation of industrial robot cells and assembly are cases used and covered in this course.
- Examiner
- Martin Hochwallner
- Scheduled hours
- 82 h
- Main field of study
- Produktutveckling, Maskinteknik